Have I mentioned lately that woodworkers are some of the most opinionated and set-in-their-way people who you will ever have the good fortune to meet? If you are a professional woodworker, then yeah, I am probably talking about you. If you are a beginner, be warned! We are going to discuss when to NOT use pocket hole screws!
Have you ever wondered how people get all those elaborate angles in their woodwork? I use to only use them when I was doing an inlay in wood flooring. Then, I started building decor pieces for my home, and I ventured fully into the territory of mitered angles that go beyond the standard 45º cut. With furniture and cabinetry, it is all about creating curves and box shapes. But when you want to get creative with something, you may find that you need some weird angle – like a 50º, 60º, or 70º miter. It can present a conundrum. So, I thought that I would show you how to cut any angle with a miter saw.
If you regularly do any type of woodworking or painting, you have probably had to use a solvent to clean your brushes. Whether you use paintbrush cleaner, mineral spirits, or paint thinner, at some point you will be faced with the issue of what to do with the leftover materials. Since we can’t pour these chemicals down the drain, and we shouldn’t pour them out on the ground, what exactly do we do with them? If you have ever wondered about this issue, keep reading, and I will share my method on how to store and dispose solvents. It’s much easier than you think!
If you have a miter saw, you may have noticed that sometimes your cuts just aren’t as accurate as you would like. Typically, this isn’t obvious until you are in the process of assembling a project – usually that very last piece – and you notice that the fit isn’t as tight as you would like. This can be very frustrating, but the good news is that your problem most likely stems from your miter saw needing to be calibrated. This is something that needs to be done from time to time. Good news! I am going to show you how to perform a miter saw maintenance for accurate cuts.
Don’t you just hate it when you are working on a woodworking project, and somewhere along the way you discover that something just isn’t right? You’ve read the instructions and you’ve followed the plans, but for some reason your pieces don’t fit correctly, or your outcome just looks wonky. It makes you just want to pull your hair out and scream. 😉 Well, before you sacrifice your hair, first take a look at the reasons why woodworking projects fail. I bet you will discover that your problem is one of these 7 issues.